Gift Card Holder

I have a really easy tutorial for a gift card holder using 

BASIC GREY's

new "B-Side" collection and embellishments.

  This only takes a few minutes to whip together, so make several to have on-hand!

 First, cut your favorite pattern of “B Side” paper to 4 1/8” X 12”. 

 Place the paper horizontally onto a scoring board.  

Score at 2.5, 3.5, 4.5, 5.5, 6.5 and 9.5 inches.

 Fold along the lines in the above fashion.

 Turn the paper over so that inside pattern is facing down.  Place a high tack adhesive tape along both sides of the 4.5” score line.  Tape each piece to the opposite side.

 

 Turn the paper back over so that the inside pattern is facing up. 

Place a small piece of high tack adhesive tape along the two edges of the

 tabs as shown above.  You now have a secure slot/pocket for any standard gift card!

If you would like to add a tab closure to the front: 

Use a 1” round die and tape it to the top of a piece of ship board so that only

 HALF of the die is exposed to the paper.  Secure to the bottom edge of the

 flap with washi tape and die-cut. 

Corner round the edges of the front flap if you wish.  Decorate with various

 embellishments from the collection and it’s ready for giving!

PRODUCTS:

B Side Collection- BSE-4913 So Anyway Paper; BSE-4925 Title Stickers;

 BSE-4927 Resin Flower Buttons; BSE-4928 Chip Shapes

Basics- BAS-4341

Candy Buttons – Aqua & Pink

Check out products and more project ideas:

www.basicgrey.com